|
[Sponsors] |
September 29, 2003, 11:17 |
Error: identifier ..... currently open
|
#1 |
Guest
Posts: n/a
|
Hi,
I accidently closed the command prompt while using gambit causing gambit to close too. When i tried to reopen the file i was working on i get the following error message Error: identifier "filename" currently open. But i can't open it. How can i get pass this or is the gambit file lost for good? Thanks, Eric |
|
September 29, 2003, 11:42 |
Re: Error: identifier ..... currently open
|
#2 |
Guest
Posts: n/a
|
You simlpy have to delete the filename.lok file in your working directory. Hope this works.
Regars, Ale |
|
September 30, 2003, 05:40 |
Re: Thanks that worked
|
#3 |
Guest
Posts: n/a
|
Thanks Ale!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
wmake compiling new solver | mksca | OpenFOAM Programming & Development | 14 | June 22, 2018 06:29 |
pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory' | mfiandor | OpenFOAM Installation | 2 | January 25, 2010 09:50 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |
OpenFOAM with IBM AIX | matthias | OpenFOAM Installation | 20 | March 25, 2008 02:36 |