Home > Forums > Software User Forums > ANSYS > FLUENT

HELP!!..Hexa using Gambit

Mark Forums Read

Reply

Search this Thread

November 3, 2003, 21:47	HELP!!..Hexa using Gambit	#1
Jim Clancy Guest Posts: n/a	Hi All, I am trying to generate a fully hexahedral mesh for a geometry consists of two horizontal concentric tubes connected by another tube vertically..I did many splits but fail to have it hexa everywhere..I need your help ..THANKS Jim

November 6, 2003, 21:14	Re: HELP!!..Hexa using Gambit	#2
Jim Clancy Guest Posts: n/a	Any comments?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gambit Startup Window	Jay Shim	FLUENT	2	February 12, 2015 15:05
Gambit help: Cube inside cube	Jack Martinez	FLUENT	13	August 11, 2010 07:29
Gambit 2.3.16, Xming or Exceed...HELP!	bambam3417	FLUENT	10	May 7, 2010 13:39
[GAMBIT] Hexa meshing two intersecting cylinders in gambit	chat1983	ANSYS Meshing & Geometry	0	April 8, 2010 08:38
Gambit -dev X11 doesn't work	Ervin Amet	FLUENT	0	October 28, 2007 09:33

All times are GMT -4. The time now is 07:50.