Home > Forums > Software User Forums > ANSYS > FLUENT

Topology change?

Mark Forums Read

Reply

Search this Thread

December 10, 2003, 04:55	Topology change?	#1
ccc Guest Posts: n/a	hi everyone, Is it possible to handle by fluent the problem with topology variation of the flow field? I think I should say more to make my meanings clear. For example, there is a brick in the wind and at some time, the brick is splitted into two leaving from each other. thanks

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Topology change and zone modification	WiWo	OpenFOAM	0	July 7, 2010 05:35
Faces during change of topology in the mesh	virginie_e	OpenFOAM Running, Solving & CFD	3	August 15, 2009 14:32
interDyMFoam gamma fluxes with topology change	sean_mcintyre	OpenFOAM	2	July 24, 2009 13:09
Change mesh topology during transient run	Alex77	CFX	2	October 31, 2007 03:35
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 06:12

All times are GMT -4. The time now is 18:55.