Change system of units?

February 4, 2004, 11:51

Hi,

I have a question about the change of units in the polyflow-postprocessor (polydata). Which values do I have to modify if I change the length unit in this way:

m -> mm

Do I have to change the following inputs:

- Carreau-Parameter (Modified cross law, fac): Pa*s -> ?

- Density: kg/m3 -> kg/mm3

- Volumetric inflow: m3/s -> mm3/s

Which of my input values do I have to change or not? Thanks for your help!

Joern

February 9, 2004, 11:13

u dont need to chage oter values

sijal

February 4, 2004, 11:51	Change system of units?	#1
Joern Guest Posts: n/a	Hi, I have a question about the change of units in the polyflow-postprocessor (polydata). Which values do I have to modify if I change the length unit in this way: m -> mm Do I have to change the following inputs: - Carreau-Parameter (Modified cross law, fac): Pa*s -> ? - Density: kg/m3 -> kg/mm3 - Volumetric inflow: m3/s -> mm3/s Which of my input values do I have to change or not? Thanks for your help! Joern

February 9, 2004, 11:13	Re: Change system of units?	#2
s` Guest Posts: n/a	u dont need to chage oter values sijal

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Cylindrical cordinate system	hamoudi	CFX	0	July 23, 2009 02:28
air change effectiveness overhead HVAC system	guillaume	Main CFD Forum	0	February 27, 2007 20:20
Need ideas-fuel discharge system	Jan	FLUENT	1	October 10, 2006 23:05
Need ideas-fuel discharge system	Jan	Main CFD Forum	0	October 9, 2006 04:27
Units for Contaminant Concentration	Rob	Phoenics	1	March 30, 2005 10:06