 |
 |
 |
|
|
|
[Sponsors] | ||||
April 19, 2004, 11:17
|
Post-processing
|
#1 |
|
Guest
Posts: n/a
|
Hi all,
I am post-processing a steady-state turbulent gas combustion simulation of a furnace, using the two-step EDM. I want to do an energy balance of the system, how can I do this and how should I present the result, i.e units? I also want to know how I can determine the residence time of the hot gases in the system? Thanks in advance, Eric |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ansys Post processing | ano999 | ANSYS | 1 | May 27, 2011 17:24 |
| NO model vs post processing in coal combustion,CFX | sakalido | CFX | 1 | April 15, 2011 15:07 |
| post processing for KIVA | dirga | Main CFD Forum | 5 | April 23, 2009 11:58 |
| Post Processing in FEM | Abhijit Tilak | Main CFD Forum | 0 | April 26, 2004 12:59 |
| post processing in CFD | MANISH BHARGAVA | Main CFD Forum | 0 | October 17, 1998 21:51 |
Linear Mode
