|
[Sponsors] |
July 11, 2004, 23:07 |
Fidap node number
|
#1 |
Guest
Posts: n/a
|
Hi,
Could you tell me how to check the node number in the middle of the 3D sturcture ? "nnumbers" gives me only the surface node numbers in the 3D sturcture. Fipost manual described about "plane" and "group" but I don't know how to define "Plane" and/or "group" command. Please let me know. |
|
July 12, 2004, 23:33 |
Re: Fidap node number
|
#2 |
Guest
Posts: n/a
|
Young:
You can use PLANE command. There you choice a point and a vector that define a cut plane. for example: PLANE(section, nonbody, pvector) Then you should indicate the point and the vector in the comand line (bottom and left) in this form: 0 0 0 1 0 0 ( push enter ) the three first numbers are the coordinates of the point (x,y,z), the next three are the direction of the normal vector of the cut plane. Finally use the command MESH for see the numbers of the nodes on this plane. MArio |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh file for flow over a circular cylinder | Ardalan | Main CFD Forum | 7 | December 15, 2020 14:06 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
Problems with mpirun | duderino | OpenFOAM | 17 | February 5, 2010 14:00 |
low turbulent reynold number | C-CARE | CFX | 4 | March 12, 2004 07:36 |
Meshing by specify a type and number of node | Jackie | CFX | 5 | April 13, 2003 17:54 |