Home > Forums > Software User Forums > ANSYS > FLUENT

No Slip / 0 shear Boundary Condition

Mark Forums Read

Reply

Search this Thread

July 29, 2004, 14:37	No Slip / 0 shear Boundary Condition	#1
evan Guest Posts: n/a	I need a wall boundary condition where I can have a temperature dependent slip condition. How can you set "no slip" for a certain temperature range and then set "zero shear" for another temperature range?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Slip Boundary Condition over the curve wall	Kelvin_mk	OpenFOAM	1	March 15, 2014 05:02
Defined Wall Shear Stress Boundary Condition	mart.hein	OpenFOAM Programming & Development	1	April 14, 2011 13:44
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05
how to set up a wall boundary condition according to calculated wall shear stress?	gameoverli	OpenFOAM Pre-Processing	1	May 21, 2009 09:28
The Boundary Condition about the Flat Plate	boing	Main CFD Forum	1	January 6, 2002 17:53

All times are GMT -4. The time now is 04:41.