|
[Sponsors] |
targeted mass flow rate at outlet in axisym case |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hi, Does anyone know what is wrong with fluent 6.1 when it calculates mass-flow rates at pressure outlets in the targeted mass-flow procedure for an axisymmetric compressible case (incompressible as well)?
Thanks |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
To those who don't follow: Case is 2D axisymmetric, 2 outlets with specified mass flow rates (targeted). Problem is that fluent seems to get areas from fluent.com or somewhere else but not the actual ones, and while iterating pays no attention to the given values of mass flow.
|
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compressible flow, no data at the outlet | mireis | FLUENT | 6 | September 3, 2015 02:10 |
CFX turbo - Mass flow rate | Vashishth Patel | CFX | 7 | April 3, 2014 20:33 |
Net mass flow inlet vs outlet | Nigui28 | FLUENT | 1 | August 12, 2011 10:09 |
mass flow rate on the Iso-clip surface & interior | Sunil Gupta | FLUENT | 0 | April 22, 2008 09:29 |
DPM outlet mass flow rate | vk | FLUENT | 1 | April 18, 2008 14:13 |