|
[Sponsors] |
March 17, 2005, 03:14 |
MRF
|
#1 |
Guest
Posts: n/a
|
HELLO. I've simulate a rotating blade using MRF method. The right hand rule was applied when determine the rotational axis. In reality, the blade rotate clockwise (Y = -1), so that in fluent I've put Y = 1 for rotational axis of rotating fluid. The problem is I got a negative lift. The blade orientation is checked for many time and its in correct orientation...
Could anybody out there help me on this problem? Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mrf doesn't work | armand | Siemens | 1 | April 1, 2011 18:46 |
Should an empty MRF zone really induce this much cross-flow? | sylvester | OpenFOAM | 5 | November 18, 2010 03:48 |
Implicit VOF + MRF | Grzegorz | FLUENT | 3 | February 27, 2009 07:11 |
MRF help please | Atul T. Shinde | FLUENT | 1 | December 19, 2002 01:20 |
Moving Mesh and MRF | Romain | FLUENT | 1 | May 16, 2002 03:45 |