|
[Sponsors] |
March 21, 2005, 10:26 |
boundary conditions validation?
|
#1 |
Guest
Posts: n/a
|
We all know that when we impose no slip conditions on a wall for example, we mean that for a viscous flow, u=v=0 for 2-dimension problem. If you write profiles in Fluent for wall surfaces, you will see that in those points, u,v are not equal to 0.0!!! And sometimes far from zero!!!!for eample 0.3 m/sec for a profile of 10 m/sec! How this is possible?It would be possible only if the code could do automatically an interpolation of velocities for accelerating the convergence. Or do i see the velocities of the cell centroid above the wall, although i am writing the profile for the wall zone? (But in the graphics window, i see values ). When i refine the mesh, values approach 0. thanks
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Impinging Jet Boundary Conditions | Anindya | Main CFD Forum | 25 | February 27, 2016 12:58 |
Boundary conditions for 2D Navie-Stockes simulation | L1011 | OpenFOAM | 5 | December 13, 2012 08:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Please help with flow around car modelling! | Tudor Miron | CFX | 17 | March 19, 2004 19:23 |
A problem about setting boundary conditions | lyang | Main CFD Forum | 0 | September 19, 1999 18:29 |