iges import to gambit

March 26, 2005, 13:17

hi,everyone.

i have made a axial pump model in CFX-Bladegen and export it to iges so that i can use gambit to mesh it.but i can't find the vertice of "hub inlet" and "case inlet",anybody can give me some advice on it?

reguards!

iceraining

March 28, 2005, 05:46

need help,thx

March 30, 2005, 22:53

hey this is not directly related to your prob, but , you can convert cfx mesh to fluent format , by utility command, ...so if can mesh with bladegen (i am assuming u can mesh with bladegen to cfx format..i never worked with bladegen),

April 2, 2005, 04:16

thank you very much! bladegenplus can build mesh,but it is too simple.now i am trying to make meshes with other tool.can you give me some advice on it? Turbogrid have some problem when the model arc is too big.

March 26, 2005, 13:17	iges import to gambit	#1
iceraining Guest Posts: n/a	hi,everyone. i have made a axial pump model in CFX-Bladegen and export it to iges so that i can use gambit to mesh it.but i can't find the vertice of "hub inlet" and "case inlet",anybody can give me some advice on it? reguards! iceraining

March 28, 2005, 05:46	Re: iges import to gambit	#2
iceraining01 Guest Posts: n/a	need help,thx

March 30, 2005, 22:53	Re: iges import to gambit	#3
zxaar Guest Posts: n/a	hey this is not directly related to your prob, but , you can convert cfx mesh to fluent format , by utility command, ...so if can mesh with bladegen (i am assuming u can mesh with bladegen to cfx format..i never worked with bladegen),

April 2, 2005, 04:16	Re: iges import to gambit	#4
iceraining01 Guest Posts: n/a	thank you very much! bladegenplus can build mesh,but it is too simple.now i am trying to make meshes with other tool.can you give me some advice on it? Turbogrid have some problem when the model arc is too big.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem importing iges file to Gambit	Tassos	FLUENT	0	May 7, 2008 05:28
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug	unoder	OpenFOAM Installation	11	January 30, 2008 21:30
iges geometry file gambit import	giacomo	FLUENT	0	May 14, 2007 13:32
Gambit iges import	pp	FLUENT	0	December 18, 2006 15:46
Gambit IGES import numeration issue	Nicolas Meynet	FLUENT	1	October 7, 2006 13:44