 |
 |
 |
|
|
|
[Sponsors] | ||||
June 8, 2005, 09:08
|
Boundary conditions problem
|
#1 |
|
Guest
Posts: n/a
|
i have a cube with a non solid interior, but the faces of the cube are all solid.I start out with a .dat array of a cube and i convert it to stl, which leaves it as a meshed face. Problem is, gambit sees the cube as just one face and I can't set the boundry conditions. is there a way to split up the faces is gambit , tgrid or fluent, or is there a way to set the boundary conditions in any of these programs with the whole cube being just one face? i just need a velocity inlet and a pressure outlet
|
|
|
||
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
| CG, BICGSTAB(2) : problem with matrix operation and boundary conditions | moomba | Main CFD Forum | 2 | February 17, 2010 03:37 |
| Fluent accuracy and boundary conditions | Paolo Lampitella | FLUENT | 0 | June 12, 2008 06:25 |
| Problem with Boundary conditions | Mahiboobswamulu | Main CFD Forum | 10 | August 26, 2003 13:24 |
| boundary conditions problem | reinaldo kuhn | Phoenics | 1 | March 27, 2003 11:46 |
Threaded Mode
