|
[Sponsors] |
August 4, 2005, 04:11 |
Write mass flow into file
|
#1 |
Guest
Posts: n/a
|
Hi!
is it possible in Fluent, to write the mass flow through a set of surfaces (e.g. from report-> surface integrals or from report-> fluxes) into a file on hard disk? I tried it with file-> write-> profiles but there are just the velocities for one coordinate – and not the corresponding areas. Ralf |
|
August 4, 2005, 05:36 |
Re: Write mass flow into file
|
#2 |
Guest
Posts: n/a
|
You could start a transcript file (file->write->start transcript) before you use the reporting options
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Problem installing on Ubuntu 9.10 -> 'Cannot open : No such file or directory' | mfiandor | OpenFOAM Installation | 2 | January 25, 2010 09:50 |
Problem with rhoSimpleFoam | matteo_gautero | OpenFOAM Running, Solving & CFD | 0 | February 28, 2008 06:51 |