|
[Sponsors] |
August 16, 2005, 10:44 |
working with mixing plane
|
#1 |
Guest
Posts: n/a
|
Hello
I`m working with a model which have two sections: stationary and movil sections. I`m using mixing plane to simulate the interface between both sections but it only reports solution on movil section. What is wrong? thanks for you suggest!! |
|
August 19, 2005, 14:42 |
Re: working with mixing plane
|
#2 |
Guest
Posts: n/a
|
go to define and then turbo topology and create turbo topology for stationary (its inlet and outlet) and then moving and then overall
hope it works |
|
August 19, 2005, 16:11 |
Re: working with mixing plane
|
#3 |
Guest
Posts: n/a
|
thanks for your suggest. I hope that it works to. We have in contact to will said you if it functioned.
See you later. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to setup mixing plane interface in STAR-CCM+ | mrjonezz | STAR-CCM+ | 3 | July 8, 2015 11:51 |
Problem with Mixing plane | Mitpostdoc | FLUENT | 0 | July 26, 2011 14:31 |
Meshing a Mixing Plane in ICEM | Will Anderson | ANSYS Meshing & Geometry | 2 | November 9, 2010 09:16 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
Mixing plane geometry definition | Hbet | FLUENT | 0 | January 18, 2002 07:16 |