Home > Forums > Software User Forums > ANSYS > FLUENT

pressure drop

Mark Forums Read

Reply

Search this Thread

January 17, 2006, 06:54	pressure drop	#1
margaret mkhosi Guest Posts: n/a	HOw do I determine the pressure drop? When I compute static pressure on inlet and outlet, using contours panel, I get two values, minimum and maximum. How do I use these values to get the pressure drop?

January 17, 2006, 07:45	Re: pressure drop	#2
Ralf Schmidt Guest Posts: n/a	Hi, see http://www.cfd-online.com/Forum/fluent.cgi?read=34573 Ralf

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pressure drop in the pipe	mike.mm	FLUENT	6	February 7, 2011 11:31
Pipe Flow - Pressure Drop	Daniel L	FLOW-3D	2	December 10, 2010 05:23
Total and static pressure drop	Janakiram	Siemens	1	February 8, 2009 02:32
Pressure Drop at entrance of a rotor-stator.	Resnick	Main CFD Forum	0	November 20, 2007 15:50
Periodic boundaries and pressure drop	MatejK	CFX	2	July 12, 2005 05:47

All times are GMT -4. The time now is 07:34.