 |
 |
 |
|
|
|
[Sponsors] | ||||
January 18, 2006, 14:23
|
Simple 2d Heat transfer question
|
#1 |
|
Guest
Posts: n/a
|
Im computing some 2d heat conduction with fluent. When I go to the flux reports window and output a heat flux Fluent gives me an answer in watts (w). This confuses me as I would think the asnswer should be in W/m since its 2d. Can anybody shed some light on this? Thanks so much Richard
|
|
|
||
|
January 18, 2006, 23:47
|
Re: Simple 2d Heat transfer question *NM*
|
#2 |
|
Guest
Posts: n/a
|
|
|
|
|
||
|
January 18, 2006, 23:49
|
Re: Simple 2d Heat transfer question
|
#3 |
|
Guest
Posts: n/a
|
I think it takes length of 1 m in the z-direction
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heat transfer coefficient - what is waht | Stan | FLUENT | 28 | December 29, 2021 17:29 |
| Two-sided Wall Heat Transfer BC - No Separate Solid Mesh and No Heat Transfer Coeff | swahono | OpenFOAM Running, Solving & CFD | 10 | October 15, 2018 06:43 |
| Heat Transfer in Porous Medium | eryan | STAR-CD | 0 | September 28, 2010 14:14 |
| Convective / Conductive Heat Transfer in Hypersonic flows | enigma | Main CFD Forum | 2 | November 1, 2009 23:53 |
| How can I increase Heat Transfer at Domain Interf? | B.Simon | CFX | 3 | October 28, 2008 19:53 |
Linear Mode
