Home > Forums > Software User Forums > ANSYS > FLUENT

UDF in batch mode

Mark Forums Read

Reply

Search this Thread

February 28, 2006, 06:47	UDF in batch mode	#1
Bogdan Guest Posts: n/a	Hi everybody, I'm trying to includ a UDF function at BC, everything is going well in GUI but when I submit the job to PBS I get the error: "Error: chip-exec: function "unsteady_pressure" not found." There are special commands to be included in the script file? Thank you for your answer Regards, Bogdan

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
to run a replayfile in batch mode from UNIX	froztbear	ANSYS Meshing & Geometry	4	May 13, 2014 09:00
Running fluent with udf in batch mode	zonexo	Fluent UDF and Scheme Programming	2	March 10, 2012 08:50
DPM model in parallel batch mode	Prashanth	FLUENT	2	March 6, 2009 08:54
A Loop problem when running UDF in the batch mode	Jun Geng	FLUENT	3	July 16, 2008 09:34
problem with running UDF in batch mode	James	FLUENT	0	June 6, 2006 07:49

All times are GMT -4. The time now is 07:48.