|
[Sponsors] |
March 1, 2006, 10:51 |
Help with particle diameter in a cell
|
#1 |
Guest
Posts: n/a
|
This is a gas flow coupled with DPM problem. The Micro only have c, t as variable but I need the particle diameter in a cell, how can I make a connection between them? Thank a lot!
|
|
March 1, 2006, 13:50 |
Re: Help with particle diameter in a cell
|
#2 |
Guest
Posts: n/a
|
Look in UDF manual for particle properties.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 22:58 |
DPM UDF particle position using the macro P_POS(p)[i] | dm2747 | FLUENT | 0 | April 17, 2009 02:29 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 05:41 |
Iclude particle diameter effect in wall? | yueroo | FLUENT | 0 | April 14, 2001 04:56 |