dynamic mesh generation

dayne

hi! i'm new to cfd and fluent. asked around on dynamic meshing but nobody knows it at my school. can somebody tell me the steps in creating a dynamic mesh of: - a twin tube damper - when the piston moves inwards;

- fluid flows through the piston orifices

- fluid flows out of the compression chamber through

base orifice to the reservoir chamber

- this means the fluid flows in two opposite directions

at the same time - any ideas/suggestions? anywhere i can find this kind/similar tutorials? please, i really need this help, this is my final year project and i need to finish it to gradute in a couple of months time.thanks a lot.