|
[Sponsors] |
March 17, 2006, 12:04 |
Not able to start a Supersonic-Calculation
|
#1 |
Guest
Posts: n/a
|
Hi,
I'm not able to start a supersonic-Calculation in FLUENT. Here the facts. Please check it! If there are any problems, please note me. thanks a lot!!! pressure_inlet: Gauge Total Pressure = 300000 Pa Initial Gauge Pressure = 0 Pa pressure_outlet: Gauge Pressure = 0 Pa Solver: Standard k-Omega-Model Steady Coupled Material: air - ideal gas cp = constant Therm. Cond. = constant Viscosity = sutherland thanks for your efforts |
|
March 18, 2006, 02:36 |
Re: Not able to start a Supersonic-Calculation
|
#2 |
Guest
Posts: n/a
|
Hi u put the static pressure in the place of Initial Gauge Pressure . For e.g For M2 For Po=295760 Pstatic is 37800 Pa.
Regards Prasatth |
|
March 18, 2006, 06:07 |
Re: Not able to start a Supersonic-Calculation
|
#3 |
Guest
Posts: n/a
|
Thanks Prasath,
How I can calculate the pressures at M = 2 ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Automatically start new calculation after the one before is completed? (FLUENT 12.1) | mars21t | FLUENT | 4 | March 27, 2011 09:52 |
Using 'define init' macro to perform a calculation at the start of a simulation | jonnythewlis | FLUENT | 0 | May 21, 2010 07:23 |
CFD calculation from transonic to supersonic flow | lawmc | FLUENT | 1 | April 6, 2010 02:47 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Supersonic flow calculation | Valery Ponyavin | FLUENT | 3 | March 28, 2004 22:28 |