|
[Sponsors] |
DPM model w/ Wave model - errors in documentation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 12, 2006, 04:37 |
DPM model w/ Wave model - errors in documentation
|
#1 |
Guest
Posts: n/a
|
Hi all!
I have noticed, when doing simulations with the Discrete Phase Model and the Wave model for spray breakup, that the Wave model is not implemented in FLUENT as described in the manual. At injection, the Wave model will re-arrange the properties of the injected discrete phase parcel, so that fewer but larger droplets are created (mass is conserved). Turning off the Wave model or using the TAB model instead removes this effect. There is nothing mentioned in the User's Guide about this. However, I have found references in the literature where the Wave model is described as often being accompanied by a collision model at injection. (The collision model in FLUENT has of course been turned off during all of my simulations). Is there anyone who also noticed this? And is there documentation on the collision model within the FLUENT-version of the Wave model available somewhere? Thank you, Henrik |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Use of k-epsilon and k-omega Models | Jade M | Main CFD Forum | 40 | January 27, 2023 07:18 |
Doxygen documentation | Tanay | OpenFOAM Installation | 9 | September 23, 2011 11:40 |
How to put melting Point data of inert particle in DPM model | subhankar_bhandari | Main CFD Forum | 0 | July 26, 2010 07:28 |
Ocean Wave Model with FLOW3D | Haryo Armono | Main CFD Forum | 0 | January 28, 1999 13:11 |