|
[Sponsors] |
Problem about FLUENT-MPCCI-ABAQUS FSI simulation! |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 24, 2006, 11:22 |
Problem about FLUENT-MPCCI-ABAQUS FSI simulation!
|
#1 |
Guest
Posts: n/a
|
After I model a two-phase flow in fluent, a structure in abaqus, MPCCI always tell me no coupling nodes when I use ABAQUS-MPCCI-FLUENT v3.04 to couple FSI problem. I build a dynamic wall In Fluent(original wall and its shadows are interface), a shell element plane in abaqus (its POS and Neg surface are interface) respectively. After scaning In MPCCI, Fluent dynamic wall become six walls, three are original walls, three for its shadows. I have set all six dynamic walls to coupling interface of FLUENT. But when I run the FSI model, MPCCI tell me some errors occured: no coupling nodes. please tell me whether MPCCI can coupling with two-phase flow (Fluent) and structure(Abaqus) or not? Why does a coupling wall in multiphase flow become three walls and what's relation are they? How to tackle my problem?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2 Way FSI Problem | alialibas | CFX | 23 | July 20, 2016 18:59 |
problem in tornado simulation with FLUENT, please help | Kestas | FLUENT | 10 | April 25, 2012 07:20 |
FSI : CFX or Fluent? | icemaniac178 | ANSYS | 1 | February 19, 2010 07:33 |
BCs in an FSI simulation of a flexble pipe | vivekcfd | OpenFOAM | 10 | January 8, 2010 05:14 |
Simulation of Two Phase Fluid Flow Problem Using Fluent 5.0 | Mohammad Al-Shannag | Main CFD Forum | 1 | July 16, 1999 12:28 |