|
[Sponsors] |
June 5, 2006, 00:51 |
Contours in 3D model
|
#1 |
Guest
Posts: n/a
|
I want to create the contours (not filled) of velocity and volume fraction in a 3D model. However, fluent asks me for selecting a surface for rending (default-interior) and this shows me the mesh. I don't want to see the mesh, just the contours. Any suggestion?
Thanks in advance, Humberto |
|
June 5, 2006, 03:38 |
Re: Contours in 3D model
|
#2 |
Guest
Posts: n/a
|
not really. display mesh in face form. then select those surfaces in contours frame and click on display. it should work
|
|
June 5, 2006, 10:41 |
Re: Contours in 3D model
|
#3 |
Guest
Posts: n/a
|
Sam, thanks for the hint!
|
|
June 7, 2006, 14:29 |
Re: Contours in 3D model
|
#4 |
Guest
Posts: n/a
|
it worked????
|
|
June 7, 2006, 15:16 |
Re: Contours in 3D model
|
#5 |
Guest
Posts: n/a
|
What I did as to create an iso-surface of water (vf=0.5), then I plotted the grid (wall) and apply transparency of 75. Then I plot the contours of the iso-surface with velocity magnitude. I got a nice figure.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Atomization and Breakup model | xck1986 | OpenFOAM | 4 | May 31, 2014 04:43 |
Problems bout CFD model of biomass gasification, Downdraft gasifier | wanglong | FLUENT | 2 | November 25, 2009 23:27 |
Reynolds Stress model in CFX vs Fluent | Tim | CFX | 1 | October 7, 2009 06:19 |
help for different between les model (subgrid-scale model) | liuyuxuan | FLUENT | 1 | October 2, 2009 15:25 |
Grid resolution for full-scale and down scaled model | gravis | Main CFD Forum | 0 | October 2, 2009 10:27 |