|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
hello everybody, I am Nikhil Lakhkar. Today is my 4th day of fluent. The problem i am facing is that whenever i tried to transfer a *.msh file from gambit to fluent or even if i try reading a case file. Fluent reads it but when i say display grid it gives me a floating point error
![]() Can anybody tell me whats the error about. Do you encountered this type of error and how to get around it. Thanks and Regards Nikhil |
|
![]() |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
||
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
MPI Error - simpleFoam - Floating Point Exception | scott | OpenFOAM Running, Solving & CFD | 3 | April 13, 2012 16:34 |
block-structured mesh for t-junction | Robert@cfd | ANSYS Meshing & Geometry | 20 | November 11, 2011 04:59 |
reactingFoam floating point exception | pajofego | OpenFOAM | 0 | November 6, 2010 17:29 |
Floating point exception error with small DeltaT | rassilon | OpenFOAM Running, Solving & CFD | 19 | September 2, 2009 07:39 |
[Gmsh] Gmsh and samplesurface | touf | OpenFOAM Meshing & Mesh Conversion | 2 | December 10, 2007 02:27 |