|
[Sponsors] |
October 3, 2006, 05:27 |
Plain-Orifice
|
#1 |
Guest
Posts: n/a
|
Hi everybody, I'm using the plain-orifice atomizer to simulate a 2d gasoil injection. How can I introduce the direction of the spray, like the 3d case? do i have just to draw a virtual side and setup it like an axis and then find a point on it from which the injection starts? Thank you!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2D axisymmetric mass flow rate for the plain orifice atomizer | jwillie2000 | FLUENT | 2 | September 17, 2010 05:43 |
Need help in modeling flow through orifice | kunal | Main CFD Forum | 0 | April 16, 2010 09:12 |
lenght and number of nodes for an orifice meter flow problem - k-eps model | fofo | FLUENT | 0 | November 15, 2009 03:49 |
Flow past orifice | aurel | Main CFD Forum | 0 | January 27, 2009 06:46 |
Orifice Flow | Prateep Chatterjee | FLUENT | 4 | February 23, 2001 14:59 |