|
[Sponsors] |
October 15, 2006, 22:04 |
Designating a part of mesh as wall
|
#1 |
Guest
Posts: n/a
|
Hi everyone, I am a student of IITMADRAS. Am new to fluent. Am simulating flow for an axisymmetric model- a cylinder of length 1m and dia 5 cm. After i mesh the cylinder can i designate part of the mesh as wall in the zone definition types??My problem is I have a wall (a single edge) at 0.25 m and i have to mesh the model around it. SO help!!!! And also any fluent users at IITM, I wud appreciate their contact details...could use help in this thing. Thanks
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] refining mesh near wall | icemaniac178 | ANSYS Meshing & Geometry | 1 | June 1, 2016 03:48 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
[Commercial meshers] tmerge utility creates unwanted interface/walls comes in the final mesh | Shoonya | OpenFOAM Meshing & Mesh Conversion | 11 | January 20, 2012 07:23 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 22:11 |
A girl fail to plot velocity profile when mesh changes + Wall function | asherah | STAR-CCM+ | 0 | February 19, 2010 18:45 |