|
[Sponsors] |
November 11, 2006, 23:29 |
problem with filter (porous-jump)
|
#1 |
Guest
Posts: n/a
|
Hi all,I have a problems here.
I try to make a filter on a GAMBIT,I specified as porous jump on boundary types.When I proceed to FLUENT,Fluent showed "cant change filter to porous jump because there is only one adjacent cell thread". What should I change on my model? What's the meaning of the words "one adjacent cell thread"? Is porous jump have a special conditions? Thanks a lot for your responses. |
|
November 14, 2006, 09:41 |
Re: problem with filter (porous-jump)
|
#2 |
Guest
Posts: n/a
|
The reason could be if you have specified the porous jump on an interface between two solid which are not joined. Jan
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Am i right? porous jump drag force | Shim | FLUENT | 2 | August 25, 2014 09:33 |
Porous jump V.S Porous zone | phxfudong | FLUENT | 1 | October 8, 2009 22:11 |
porous media/jump mass flow problem | Marijo | FLUENT | 0 | February 17, 2006 11:49 |
problem about droplets in porous | cck | Siemens | 0 | August 6, 2005 00:48 |
POROUS SURFACE MESHING PROBLEM | subramani.j | Siemens | 1 | March 3, 2004 04:45 |