|
[Sponsors] |
February 8, 2007, 12:46 |
Error when meshing
|
#1 |
Guest
Posts: n/a
|
Hi all,
Please help me. I m a new user. I used Gambit to construct a basic cylinder which will represent a gasifier. Nearly at the bottom of the cylinder, I construct 9 nos. of nozzles by using cylinder also. Those nozzles located circumferential the gasifier. Then I substract those volumes so that I can get a gasifier with penetrated holes(nozzles). The problem is error message came out: ERROR: Imprinting of projection edges failed when meshing volume volume.1. Check to insure that source faces are correct. Please tell what went wrong? By the way, how we can know that the meshing scheme we choose is appropriate for our model? On what basis we are supposed to choose the scheme? Thanks in advance. rayy |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 05:01 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |