 |
 |
 |
|
|
|
[Sponsors] | ||||
March 15, 2007, 12:09
|
Zone types and Solid
|
#1 |
|
Guest
Posts: n/a
|
In GAMBIT there is an option in specifying continuum types of Solid or Fluid. I have a geometry through which air is passing and flowing on the outer side also (like a picture frame placed in Wind tunnel). Problems to ask are: 1) Should I take the geometry as a volume and mesh it and then specify it as a Solid in zone type? 2) Shuld I take the faces of the geometry only and specify them as wall? If I do this and specify the oruter domain as a volume then in Fluent only the outer volume is shown and not the geometry!!!!! Kindly help me SHAMOON
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Multiple Solid Domains - Interfaces | Scott | CFX | 8 | July 31, 2008 16:20 |
| [Commercial meshers] FluentMeshtoFoam with internal solid surface | mayank | OpenFOAM Meshing & Mesh Conversion | 3 | May 30, 2007 03:57 |
| Zones.....> Solid | Shamoon | FLUENT | 2 | March 21, 2007 12:30 |
| Zone types---->Solid | Shamoon | FLUENT | 0 | March 15, 2007 12:06 |
| How to solve 2 diferrent specify continuum types | tuw | FLUENT | 2 | October 28, 2006 12:30 |
Linear Mode
