Home > Forums > Software User Forums > ANSYS > FLUENT

pump meshing inside the sump

Mark Forums Read

Reply

Search this Thread

March 16, 2007, 07:57	pump meshing inside the sump	#1
ashwin Guest Posts: n/a	Hello All, How are you? I have modelled a pump with a outside thickness of 25.4mm and want to mesh it once it is inside the sump. The pump has 4 vanes. I have created a single volume by subtracting it from the sump. The tough part is the mesh. please advice. Thankyou Ashwin.C.Punjabi

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
confused with meshing pump with turbogrid	eng_norouzi	ANSYS Meshing & Geometry	0	August 19, 2011 15:02
[Commercial meshers] Meshing one surface inside the other	premns	OpenFOAM Meshing & Mesh Conversion	4	June 30, 2011 05:11
Pump in a sump meshing	Ashwin C Punjabi	FLUENT	0	March 13, 2007 00:52
UDF for dynamic meshing of lube pump	vinay kulkarni	FLUENT	0	February 20, 2007 15:17
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 13:37

All times are GMT -4. The time now is 21:55.