|
[Sponsors] |
March 23, 2007, 01:42 |
TGrid query
|
#1 |
Guest
Posts: n/a
|
Hi folks,
Is it possible to project nodes onto a planar zone (created by "Boundary ---> Create ---> Plane Surface") and remesh the planar zone such that the projected nodes are used to remesh the plane? I have the boundary edge loops of my 3D surface mesh created through "Boundary ---> Feature" panel. I wish to project the boundary edge loop nodes that are within a threshold distance of the aforementioned plane. Pls advise. I use TGrid 4.0.16. Vivek |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Cannot convert fluent or tgrid hexcore mesh | aerogt3 | OpenFOAM Meshing & Mesh Conversion | 2 | October 22, 2010 11:55 |
CFX Pre - TGrid | Vivek Vasudevan | CFX | 2 | March 20, 2007 06:31 |
TGrid: segmentation violation error | Vincent | FLUENT | 0 | February 15, 2006 10:34 |
Drawing in TGrid | Harmeet | FLUENT | 0 | September 22, 2004 03:56 |
to tgrid or not to tgrid | Nurul Murad | FLUENT | 1 | July 6, 2001 13:21 |