Home > Forums > Software User Forums > ANSYS > FLUENT

high pressure exhaust flow

Mark Forums Read

Reply

Search this Thread

March 25, 2007, 15:10	high pressure exhaust flow	#1
Exhausted Guest Posts: n/a	Is it possible to get reasonable results from flowing exhaust ports when flow is sonic or above? I've been told by many knowledgeable experts that it cannot be done accurately. I want to flow an exhaust port with the valve at low lift and upstream/downstream pressure ratio equaling 2:1.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Compressible flow, no data at the outlet	mireis	FLUENT	6	September 3, 2015 03:10
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 07:27
pressure distribution in water flow, differences in icoFoam and COMSOL	deniggo	OpenFOAM Running, Solving & CFD	14	September 30, 2010 04:48
Simulating high pressure burst flow	jakjak	CFX	2	November 21, 2007 22:06
Multicomponent fluid	Andrea	CFX	2	October 11, 2004 06:12

All times are GMT -4. The time now is 11:45.