 |
 |
 |
|
|
|
[Sponsors] | ||||
June 28, 2007, 08:19
|
mesh scale info
|
#1 |
|
Guest
Posts: n/a
|
Hey all,
I'm attempting dynamic meshing in Fluent and i'm relatively new to it. I am trying to deform the model using remeshing. When my model is loaded in Fluent and i switch remeshing on the mesh scale info gives me the default value of 1e20. Other models i load bring in the correct info without doing anything differently. How do I acquire this information? Thanks, Dave |
|
|
||
|
July 9, 2007, 14:33
|
Re: mesh scale info
|
#2 |
|
Guest
Posts: n/a
|
I need to know mesh number for a stone of 2cm. thanks
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
| engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
| [ICEM] Mesh info for a particular Block | vmlxb6 | ANSYS Meshing & Geometry | 1 | May 2, 2011 05:53 |
| calculate time scale for mesh deformation analysis | wilsonbrad | CFX | 1 | October 23, 2009 06:44 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Linear Mode
