|September 8, 2007, 10:15||
Extremely high Epsilon
I've got a flow domain that is enclosed within walls (a gas turbine combustor) but the value for epsilon is extreme close to some walls where the flow velocity is high.
This seems to be caused probably by the boundary layers I've used to increase density for the no slip condition. This is required for adequete mixing.
The fuel I'm modelling is sticking to the walls as if it were oil, even though the first 6 grid rows are very dense.
Does anyone know how to create an appropriate grid that accurately predicts epsilon?
|Thread||Thread Starter||Forum||Replies||Last Post|
|SimpleFoam k and epsilon bounded||nedved||OpenFOAM Running, Solving & CFD||15||December 2, 2016 03:40|
|Extremely high Temperature needed to simulate pressurization with rhoCentralFoam||shangzung||OpenFOAM Running, Solving & CFD||0||August 6, 2010 06:35|
|k and epsilon Values for High Pressure Water||nikhiljain.iitk||FLUENT||0||March 12, 2010 07:06|
|SimpleFoam k and epsilon bounded||nedved||OpenFOAM Running, Solving & CFD||1||November 25, 2008 21:21|
|Multicomponent fluid||Andrea||CFX||2||October 11, 2004 05:12|