 |
 |
 |
|
|
|
[Sponsors] | ||||
September 20, 2007, 23:53
|
Boundary layer meshing
|
#1 |
|
Guest
Posts: n/a
|
I have a 2-d model. When i m trying to give a boundary layer mesh, this is the error i m getting
"The available length of the adjoining edge is less than the total depth of the boundary layer" can anybody tell me wht it means... Pls help me thanks in advance |
|
|
||
|
September 21, 2007, 09:51
|
Re: Boundary layer meshing
|
#2 |
|
Guest
Posts: n/a
|
It means
a+...+a*(x)^(n-1) > L a, size of first layer x, increasing factor n, number of boundary layers L, 'length of the adjoining edge' so, decrease either a, x or n. |
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
| A question on "Specifying Boundary Layer Deformation Smoothing" | didiean | FLUENT | 2 | January 16, 2012 21:39 |
| Meshing with hexaedral and boundary layer | sophie-l | Main CFD Forum | 1 | May 20, 2009 22:18 |
| Boundary layer meshing with sharp trailing edges | Andrew Berner | FLUENT | 1 | August 28, 2007 17:39 |
| New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |
Linear Mode
