|
[Sponsors] |
September 27, 2007, 00:53 |
inverted elements in gambit
|
#1 |
Guest
Posts: n/a
|
I have been meshing a fluid domain consisting of elements to order of 2.5 million. Now found that last volume being meshed contains 1 inverted element & results in negative volume. It's not possible to revert back from starting the mesh again. Is there any means to suppress the inverted elements? or are there any commands to smoothen the mesh which can lead to better results. Please note it does in gambit.
Thanks in advance. Abhijit Kulkarni. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Inverted and Skew Elements - Gambit | ronakkaria | ANSYS Meshing & Geometry | 1 | June 21, 2011 02:03 |
[Gambit] inverted elements / negative volume | jack1980 | ANSYS Meshing & Geometry | 1 | February 22, 2010 01:50 |
Inverted elements in gambit | Geoffroy Chaussonnet | FLUENT | 2 | April 25, 2007 01:43 |
inverted cells in Gambit | nd | FLUENT | 3 | July 3, 2005 22:58 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |