Home > Forums > Software User Forums > ANSYS > FLUENT

Wet combustion

Mark Forums Read

Reply

Search this Thread

October 5, 2007, 05:17	Wet combustion	#1
IgorB Guest Posts: n/a	Hello! I have a problem modeling biomass cobustion using Fluent. I have used non-premixed comb. with two mixture fraction model. One stream representing char and the other representing volatiles (empirically defined). I don't really know how to include moisture. Is it possible to use wet combustion model with non-premixed comb. and how? The manual says virtually nothing about wet combusting model and how to turn it on. Thanks in advance. Igor B.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 06:21
Modelling Combustion in Porous Zone	tanjinjack	FLUENT	2	September 26, 2016 05:10
Constant velocity of the material	Sas	CFX	15	July 13, 2010 09:56
WET COMBUSTION	DEV	FLUENT	0	August 28, 2008 10:40
Problem with WET COMBUSTION	DEV	FLUENT	3	August 27, 2008 01:37

All times are GMT -4. The time now is 22:32.