|
[Sponsors] |
Question about pressure inlet boundary condition. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 30, 2007, 07:24 |
Question about pressure inlet boundary condition.
|
#1 |
Guest
Posts: n/a
|
I am now simulating a 2D blade cascade problem. The object is one 2D blade with its channel. Periodic boundary conditions are used on the sides of the passage. Now I have to put pressure boundary conditions on inlet and outlet. I know the total pressure of inlet and static back pressure of outlet, but I don't know static pressure of inlet, so I use 0 Gauge pressure of the static pressure. However, the program always send error messages. Even I change the static pressure of inlet, the error is always there. Is it important to set the static pressure of inlet exactly? Or what would happen to cause this kind of message?
The message is like "temperature divergence", "pressure divergence", etc. |
|
November 30, 2007, 07:39 |
Re: Question about pressure inlet boundary conditi
|
#2 |
Guest
Posts: n/a
|
Hi Alina,
You have to check the Solution Control, especially the under-relaxation factors and discretizations. For more information for under-ralaxation factors: http://venus.imp.mx/hilario/SuperCom...e615.htm#92857 For more information for discretizations: http://venus.imp.mx/hilario/SuperCom...ml/node606.htm good luck Hai Duc |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure boundary condition | C-H Kuo | Main CFD Forum | 18 | September 16, 2016 03:19 |
velocity profile inlet boundary condition question | Lcw | FLUENT | 3 | August 3, 2012 05:53 |
Implications for heat transfer when outlet pressure boundary condition used | Blob | CFX | 2 | March 26, 2009 06:22 |
pressure with velocity inlet boundary conditions | Ashraf Sharara | FLUENT | 1 | August 21, 2008 07:29 |
may I use Pressure inlet Boundary as free surface? | duci | FLUENT | 0 | August 23, 2002 22:29 |