|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
I'm working on tangential fired boiler simulation now and have the following queries.
1. DPM injection of coal: When I define dpm injections for coal particles, the mass flow rate of the injection is on dry-ash-free basis or jus the coal flow rate as such. Because, I am converting the heating value of coal to daf basis. While creating PDF table, I give the elemental composition on daf basis. But during the dpm injection, my injecting particle is Coal medium volatile. 2. I am interested in obtaining heat flux through the wall. While defining the boundary conditions for the wall I am defining wall temperature and internal emissivity. I am using the values 1200 K and 0.65. Are they fair enough? Or is there anyway of arriving with more exact numbers for a specific case? 3. As the dpm iterations proceed (i'm having a dpm iteration for every 20 continuous phase iterations), the number of particle escaped is decreasing and the no of particles incomplete is increasing. why is this happening? does it got any significance? Thanks from, Yogesh |
|
![]() |
![]() |
![]() |
#2 |
Member
Maaz Ul Mosaid
Join Date: Jan 2014
Location: Pakistan
Posts: 32
Rep Power: 11 ![]() |
Have you got any success ? please share with me
|
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Nonpremixed Combustion Model for Coal Gasification | C.Y.Ler | FLUENT | 2 | April 29, 2014 08:51 |
Help me for the simulation on hydrogen/air combustion | xulixian | CFX | 1 | April 16, 2009 15:57 |
Coal combustion tutorial | Chetan | FLUENT | 3 | May 4, 2007 00:11 |
Modelling Coal Combustion like a fluid | Dr. Flow Squad | FLUENT | 1 | March 21, 2007 13:47 |
coal combustion simulation | cxysohu | FLUENT | 6 | November 2, 2006 02:21 |