 |
 |
 |
|
|
|
[Sponsors] | ||||
February 17, 2008, 09:49
|
ISO SURFACE
|
#1 |
|
Guest
Posts: n/a
|
Hi, I'm modeling an open channel flow.. I want to track the air water interface.. I 've an ISO SURFACE with 0.5 value, for Volume Fraction Now, when I display it, it doesnt show the air water interface.. any idea where i'm getting wrong.. Here is the picture of what I get..
http://cid60157d8f9414c461.skydrive....lf.aspx/Fluent%20Project-/iso-surface.JPG Thanks in advance |
|
|
||
|
February 17, 2008, 09:51
|
Re: ISO SURFACE
|
#2 |
|
Guest
Posts: n/a
|
Please copy paste the link in new window if you fail to see the image http://cid-60157d8f9414c461.skydrive...lf.aspx/Fluent%20Project-/iso-surface.JPG
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
