|
[Sponsors] |
February 18, 2008, 03:54 |
Fluent Post Processing
|
#1 |
Guest
Posts: n/a
|
Hi... I am studying a case of flow past cylinder. Cylinder is placed perpendicular to the stream direction inside a rectangular duct. (Re - based on pin dia, vmax < Re,critical). Turbulent, Incompressible, steady, 3d, air flow).
Question: Whether it is possible to plot any property (say., Static pressure distribution) on the developed surface of pin circumferential face. ie., if the pin surface is developed, i will get a rectangular sheet. On that i would like to plot the static pressure distribution of the pin. Thanks in advance. Kulasekharan PhD Scholar, IIT Madras |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys Post Processing | Brian_P | Main CFD Forum | 0 | March 4, 2010 17:05 |
Surface Post Processing | Graham | Main CFD Forum | 0 | November 11, 2009 15:49 |
Post processing in FLUENT | praveen.jpk | FLUENT | 1 | September 10, 2009 02:58 |
Different in fluent result after post processing | Niles | FLUENT | 0 | August 14, 2008 05:28 |
post processing in CFD | MANISH BHARGAVA | Main CFD Forum | 0 | October 17, 1998 21:51 |