|
[Sponsors] |
June 29, 2008, 19:06 |
Gambit geometry problem
|
#1 |
Guest
Posts: n/a
|
I'm using AUTODESK Inventor to create a business jet and simulate it using Fluent. I have loaded my design into Gambit and am now running into a small problem. The outside part of the cylinder which represents the engine are not showing up. I don't know if the problem is occuring in Gambit or in my Inventor model. Also, I have a second smaller cylinder inside of the engine to represent the turbines. This area is being covered by the front and back of the same cylinder I am having problems with above. If anyone has run into this problem and gotten around it please let me know how you fixed it. Thanks.
- Chase |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit - Mesh Problem for a complex 3D geometry | Nelson | FLUENT | 3 | May 28, 2012 06:57 |
Gambit geometry creation: loading data to gambit | C Ariyaratne | FLUENT | 10 | March 17, 2011 16:39 |
GAMBIT, CAD import, clean up geometry problem | Nuray Kayakol | FLUENT | 1 | December 30, 2007 11:43 |
Problem importing GAMBIT mesh to Ansys geometry | David G. | CFX | 0 | June 19, 2005 06:01 |
problem about Importing geometry in Gambit | Hua Gu | FLUENT | 3 | April 2, 2002 14:24 |