|
[Sponsors] |
walls that should be interior (but i cant find it) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
February 20, 2012, 20:23 |
walls that should be interior (but i cant find it)
|
#1 |
Senior Member
mohamed khedr emam
Join Date: Oct 2011
Location: Egypt
Posts: 121
Rep Power: 14 |
hi guys. i am working in a H.A Wind turbine . i did make the geometry in solidworks and did the mesh in Ansys. the problem is that i have some interior faces and when i ran the fluent i have walls instead of interior bc.
i have two main zones: the one that its' close to the blades and the other one that's away. i set up a interface in between this two because the interior one is moving while the exterior is fixed. the problem is in the wall zone. i should convert it to interior but the available types is inlet, outlet , interface, etc.... i try to use fuse option but didnt work can anybody help me? thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFoam171: error /usr/bin/ld: cannot find -llduSolvers | Schipper | OpenFOAM Programming & Development | 9 | August 26, 2020 05:31 |
OpenFOAM 1.6-ext git installation on Ubuntu 11.10 x64 | Attesz | OpenFOAM Installation | 45 | January 13, 2012 12:38 |
Problem Building OF on Centos cluster (no admin rights) | CKH | OpenFOAM Installation | 5 | November 13, 2011 06:32 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
YPlus nowhere to be find | Daniel | CFX | 3 | May 1, 2006 16:22 |