 |
 |
 |
|
|
|
[Sponsors] | ||||
July 22, 2008, 00:56
|
Meshing problem in gambit
|
#1 |
|
Guest
Posts: n/a
|
I am trying to construct a tubular reactor with central portion heated by a furnace with closed end flange at either ends with inert gas inlet/outlet. I am trying to construct the geometry in gambit. How to go about it. Plz help.
|
|
|
||
|
July 22, 2008, 05:23
|
Re: Meshing problem in gambit
|
#2 |
|
Guest
Posts: n/a
|
Concentrate only the fluid region. Its a simple model. Regards
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem meshing with Gambit | Adrian | FLUENT | 8 | October 7, 2008 09:39 |
| Gambit meshing problem | David Banks | Main CFD Forum | 0 | July 19, 2007 12:48 |
| 3D-gambit meshing problem | prem | FLUENT | 3 | February 28, 2006 03:42 |
| GAMBIT meshing problem | George | FLUENT | 2 | October 30, 2003 09:50 |
| meshing problem with gambit. | jx | FLUENT | 2 | June 30, 2003 05:05 |
Linear Mode
