|
[Sponsors] |
July 31, 2008, 05:30 |
Patching region and Under Relaxation Factors
|
#1 |
Guest
Posts: n/a
|
hi, i start to generate the model in 2d & further proceed to 3d model. I am trying to study the fluidization of solid particles with carrier gas, flow analysis & the profile within the mill including pressure distribution , velocity & volume fraction for both phases. How about 'patching' region in 2d & 3d models? What are the special attention i should give in setting the pressure, momentum, volume fraction, turbulant viscosity ratio etc. for convergence? thank you.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
TUI command for patching region | Tristan Collins | FLUENT | 3 | May 6, 2019 06:19 |
Under relaxation factors | ro | FLUENT | 3 | April 17, 2008 13:44 |
Under-Relaxation Factors | anitga | FLUENT | 0 | April 21, 2006 12:18 |
relaxation factors | Roberto Ciardulli | Siemens | 3 | October 26, 2000 11:35 |
regarding under relaxation factors | swati | FLUENT | 1 | December 10, 1999 11:09 |