|
[Sponsors] |
October 6, 2008, 10:36 |
Surface Integral - Mass Flow Rate
|
#1 |
Guest
Posts: n/a
|
Hi All,
I am I have created a plane using Surface -> Plane. ( it create plane-19) But when I check the mass flow rate in using surface integral on that it gives some mass flow rate which is different from the mass entering the domain. The results look resonable. Did any one has come across similar issue and any solution ? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mass flow rate of the DPM mass sourse ?? | Rhinocao | FLUENT | 3 | January 21, 2011 12:10 |
mass flow rate on the Iso-clip surface & interior | Sunil Gupta | FLUENT | 0 | April 22, 2008 09:29 |
Mass Flow Rate on the Interior Surface | Barii.Johnason | FLUENT | 24 | May 11, 2007 17:59 |
monitor surface integral & report surface integral | Ning | FLUENT | 0 | March 18, 2007 12:51 |
How are the mass flux and mass flow rate defined? | Miles | Siemens | 2 | November 7, 2002 08:45 |