|
[Sponsors] |
November 7, 2008, 01:30 |
high pressure simulation
|
#1 |
Guest
Posts: n/a
|
Hi,
I am doing a flow simulation inside an engine. The domain is the space between the piston and the cylinder. It is a 2 phase flow with air and oil, with a time varying pressure and temperature at the inlet and ambient conditions at the outlet, with one outer wall moving(sinusoidal profile). The pressure can be as high as 50 bar at some point in time. The mesh has been completed and the simulation is running fine with simple flow conditions. Do I have to make any changes to the supersonic pressure condition at the inlet when I test with high pressure? Right now I am getting floating point error at high inlet pressure. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simulation of airfoil at high AOA | hsnu84053 | FLUENT | 0 | January 26, 2007 21:34 |
high pressure gas release | ahourri | FLUENT | 0 | November 16, 2005 23:45 |
MRF simulation : continuity residual high as 0.4 | guru | FLUENT | 2 | February 7, 2005 09:33 |
Injection at high pressure | florian(munich) | FLUENT | 0 | October 28, 2004 13:59 |
FIDAP-simulation with high viscotities | Wolfgang Korte | FLUENT | 2 | November 2, 2000 13:14 |