|
[Sponsors] |
November 11, 2008, 11:48 |
[Gambit] Very simple mesh but derformed
|
#1 |
Guest
Posts: n/a
|
Good evening,
I'm working on a very simplified geometry of a 2D nozzle with Gambit 2.2.30. The mesh is as simple as possible and nevertheless, it's deformed as you can see here : http://imagik.fr/view-rl/152656 I've noticed that if I add more nodes, the deformations are more and more important. So, it's possible to avoid any deformations if there is a very few number of nodes. Of course, this solution is not acceptable. Could you give me any advice ? Do I forget something ? Thanks in advance for any help... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Simple Gambit problem | Meenu | FLUENT | 2 | December 10, 2007 02:25 |
Gambit bug on very simple 2d Faces?! | Xie | FLUENT | 0 | June 17, 2007 11:51 |
simple Gambit face geometry | jdb | FLUENT | 4 | December 17, 2005 10:40 |
simple+Gambit+Heat transfer+mesh+problem+ha ha | susan | FLUENT | 1 | February 2, 2004 04:40 |
Simple Meshing Problem with Gambit | Mario | FLUENT | 4 | April 18, 2003 09:52 |