|
[Sponsors] |
February 5, 2009, 12:38 |
Mass & Pressure Boundaries
|
#1 |
Guest
Posts: n/a
|
Hi,
Pressure values (total pressure at inlet and static pressure at outlet) of system are calculated initially by using the mass inflow and mass outflow boundaries. Then for the same system, the mass boundaries are replaced with the pressure inlet and pressure outlet boundary conditions (values used are the total and static pressures calculated initially). Can I expect to get back the mass flow rates with which I started the problem? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mass & Pressure Boundaries | kantipudi | Main CFD Forum | 0 | February 5, 2009 12:37 |
pressure boundaries | killian | FLUENT | 0 | November 25, 2006 09:37 |
mass fraction specification @ pressure boundaries! | Mazyar | FLUENT | 0 | April 28, 2006 13:35 |
mass flux correction at outflow boundaries | Subhra Datta | Main CFD Forum | 2 | November 24, 2003 13:11 |
mass flow boundaries | Ragnhild Halden | CFX | 6 | September 3, 2001 03:56 |