Any body help me!, Impeller simulation problem.

March 5, 2009, 11:12

I have the problem regarding to radial flow close type impeller of water centrifugal pump, for many time I tried to run by single blade with periodic flow k-epilon reslizable, single domain rotaion with 2900 rmp and structed hex mesh type ,simple scheme and the others by second order upwind, but the results is still not convergence both mathmatics, physical and also reverse flow appeared at the outlet pressure.

Any body is expertise in this field please help me, I will send the Case and data files via email for discuss the problem, thank you for your kindly.(thomas_crown20@hotmail.com)

March 7, 2009, 13:06

Hi,

I have very good expereince in turbomachinery CFD. Send your cas and dat files at my email id.

Regards

Genesis760 · June 9, 2009, 13:04

Hi everybody.
I have the same problem with a simply 3D geometry with an impeller in it. I want to see a good velocity profile but i don't know how to set a proper boundary condition. Can anybody help me? Tnx

March 5, 2009, 11:12	Any body help me!, Impeller simulation problem.	#1
Desperado Guest Posts: n/a	I have the problem regarding to radial flow close type impeller of water centrifugal pump, for many time I tried to run by single blade with periodic flow k-epilon reslizable, single domain rotaion with 2900 rmp and structed hex mesh type ,simple scheme and the others by second order upwind, but the results is still not convergence both mathmatics, physical and also reverse flow appeared at the outlet pressure. Any body is expertise in this field please help me, I will send the Case and data files via email for discuss the problem, thank you for your kindly.(thomas_crown20@hotmail.com)

March 7, 2009, 13:06	Re: Any body help me!, Impeller simulation problem	#2
Sa Guest Posts: n/a	Hi, I have very good expereince in turbomachinery CFD. Send your cas and dat files at my email id. Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Questions on an impeller simulation with Fluent	Angelo D'Ettore	FLUENT	4	July 7, 2010 10:08
Sample simulation of axial flow impeller in a duct	Vashishth	CFX	1	November 16, 2008 19:34
simulation of centrifugal impeller	Txema	FLUENT	1	February 23, 2007 01:08
TASCflow - Impeller Simulation	Centaur_ks	CFX	2	May 27, 2003 12:02
Problem about 3D blunt body high Re simulation	David	FLUENT	0	September 27, 2002 10:59

June 9, 2009, 13:04		#3
Genesis760 New Member Join Date: Jun 2009 Posts: 1 Rep Power: 0	Hi everybody. I have the same problem with a simply 3D geometry with an impeller in it. I want to see a good velocity profile but i don't know how to set a proper boundary condition. Can anybody help me? Tnx